Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
GAF Driveway & Pavers: The Dallas Owner’s Guide
GAF driveway and paver work in Dallas typically runs $7,000 to $18,000 installed for a full paver driveway, with repairs and partial replacement starting lower depending on square footage and substrate condition. We stock GAF-compatible paving components and install them with a written line-item price before any work starts. Most Dallas homeowners discover they have a problem after a heavy rain exposes a sinking paver section or a visible crack runs through a previously solid surface.
The failure usually starts below the surface. Dallas’s clay-heavy soil expands and contracts through our hot summers and occasional freezes, which heaves pavers out of alignment. Once water gets under the paver base, the subgrade washes out and you get dips, rocking pavers, and eventually broken units. By the time you see the symptom, the base has usually been failing for months.
We’re an independent Dallas contractor, not a GAF affiliate. We install GAF-spec paving systems and source GAF-compatible materials through our documented brand roster.
Which GAF Models This Applies To
GAF doesn’t manufacture pavers the way it manufactures shingles, but GAF’s driveway and hardscape line covers underlayment, base reinforcement, and paver-compatible drainage systems used under Belgard and Unilock pavers in Dallas installations. The compatibility question is less about a “model number” and more about the system underneath: permeable base mats, edge restraints, and the GAF drainage membranes that sit between your soil and the paver bed.
Here’s the compatibility gotcha most Dallas homeowners run into: if your existing driveway was poured as a concrete slab and you want pavers on top, you can’t just lay pavers over it. The concrete traps water, and trapped water in Dallas soil means heaving. You either remove the slab, or you install a drainage layer between the concrete and the paver base. That decision changes the job by thousands of dollars, and it’s the first thing we check on a site visit.
For OEM versus aftermarket: GAF drainage membranes and underlayments are engineered to specific flow rates and load ratings. A generic hardware-store landscape fabric is not a substitute. It tears under paver weight, clogs with Dallas clay, and fails within two seasons. We document the exact GAF-spec product or an equivalent manufacturer’s product with matching load and flow specs so you can trace what went under your driveway.
Styles & brands we work with
Signs Your GAF Driveway & Pavers Is Failing
- Rocking or wobbly pavers. The paver itself isn’t broken; the base under it has washed out. In Dallas, this usually shows up after spring rains. One rocking paver means water is already moving through the base.
- Low spots that hold water after rain. The subgrade settled unevenly. If water pools for more than an hour after rain stops, the base has compacted poorly or eroded. Every pooling spot is a future crack.
- Sand washing out between joints. Polymeric sand is the glue that locks pavers together. When it erodes, pavers start shifting. Dallas’s clay soil makes this worse because the ground underneath doesn’t drain well.
- Cracked or chipped paver edges. Heavy vehicle traffic on a weakened base transfers the load unevenly. The paver edge takes the stress and chips. Once chipping starts, it spreads along the whole section.
- Edge restraints pulling away. The plastic or aluminum edging along the driveway perimeter is buckling or lifting. The restraint is failing, which lets pavers drift outward. If you catch this early, it’s a smaller repair; ignored, the whole edge row collapses.
Replacement Cost & What’s Included
Paver driveway installation in Dallas runs $7,000 to $18,000 installed. The spread depends on square footage, whether we’re removing an existing concrete slab, the paver brand and pattern, and how much base excavation your soil requires. Repairs to a failed section, like re-setting a sunken area or replacing broken pavers on a small scale, generally falls in the $1,500 to $5,000 range depending on how far the base damage extends.
| Scope | Typical Range |
|---|---|
| Full paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Paver repair (section reset) | $1,500 – $5,000 |
| Driveway sealing (asphalt) | $250 – $700 |
Every price comes as a written line-item quote before we order a single paver. You’ll see the material cost, base prep, labor, and disposal listed separately. No numbers move once the work starts. And every completed job carries the 365-Day Done Right Promise: if the work fails within one year, we come back and correct it at no charge.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely inspect your own driveway. Walk the surface after a rain and mark every paver that rocks or every spot that pools. That tells you the extent of the problem and gives you a rough sense of the scope before anyone quotes the job. You can also check the edge restraints by looking for gaps between the pavers and the border.
You should not attempt paver base repair yourself. The danger isn’t springs or electricity here; it’s that a poorly compacted base fails again within two years and you’ve spent a weekend and a thousand dollars on materials that now need to be torn out. Proper subgrade repair in Dallas means excavating to the right depth, adding crushed stone in lifts, compacting each lift, and installing the drainage layer. Most rental compactors at big-box stores can’t achieve the density needed for vehicle traffic.
If you want a straight answer on whether your driveway can be salvaged or needs a full reset, call (903) 326-8963. We’ll assess it, give you a written number, and you decide.
FAQs
A properly installed paver driveway in Dallas should last 25 to 40 years. The pavers themselves rarely wear out; what fails is the base underneath, especially with our clay soil and freeze-thaw cycles. A driveway that fails in under 10 years almost always failed because of base preparation or drainage, not the paver itself. Call (903) 326-8963 and we’ll tell you exactly what’s happening under your pavers.
Yes, in most cases a sinking section can be lifted, the base re-leveled and re-compacted, and the same pavers reset. This costs significantly less than a full replacement. The exception is when the base has eroded completely or the subgrade has a drainage problem that requires new pipe or a different base design. We’ll give you an honest read when we see it.
A section repair usually takes one to two days. A full paver driveway installation typically runs three to five working days, depending on whether we’re removing an existing slab and how much excavation your soil requires. You’ll have a dated timeline in writing before we start, and we hold to it. Call (903) 326-8963 for a schedule estimate on your specific project.
We keep common GAF drainage membranes, edge restraints, and polymeric sand on our trucks and in our Dallas stock. Pavers themselves are ordered per job in the specific brand, color, and pattern you choose, since there are hundreds of combinations. We also work with Belgard and Unilock paver lines, along with our documented rosters for KraftMaid, Cambria, and Silestone for interior work. Call (903) 326-8963 and we’ll confirm what’s available for your project.
Contact Bradford Remodeling Co Dallas
If your GAF-spec driveway or paver surface is failing, call (903) 326-8963 for a free estimate. Curtis Lane runs the crew, and the standard is simple: written price before work starts, documented scope, clean site at close, and a signed guarantee in your hand. Straight number, real scope, no surprises on delivery day.
Written by Curtis Lane, Owner, Bradford Remodeling Co Dallas at Bradford Remodeling Co Dallas, serving Dallas and nearby areas.
