Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tuff Shed Fence Installation: The Dallas Owner’s Guide
A Tuff Shed fence installation in Dallas typically runs $3,500 to $9,000 installed, depending on the fence length, material, and whether you’re fencing around a new shed or replacing an existing run that’s failed. We stock Tuff Shed-compatible fence materials on the truck and can usually complete a standard perimeter fence around a shed in one to two days.
The way most Dallas owners find this page is the same story: the shed went up fine, the fence went in later, and now the gate sags, a post leans, or a bottom board has rotted out where the sprinkler hits it. You want it fixed without redoing the whole fence line and without a contractor who treats a small job like an inconvenience.
Which Tuff Shed Models This Applies To
This applies to any Tuff Shed structure you’d fence around or attach a fence to: the Premier Pro Series, the Premier Ranch, the Sundance Series, and custom builds ordered through Tuff Shed’s Dallas-area sales centers. The fence installation itself is independent of the shed model because Tuff Shed manufactures buildings, not perimeter fencing. That matters in one specific way: the fence does not tie into any shed warranty. Tuff Shed won’t cover a fence we install, which is why the 365-Day Done Right Promise from Bradford Remodeling exists, so you’re still covered in writing.
What does affect compatibility is how the fence meets the shed. The standard approach is a freestanding fence run that butts against the shed’s outer wall with a 1-inch clearance gap. If you want the fence physically attached to the shed wall, we lag the rails into the shed’s wall framing, never into the siding alone, because Tuff Shed’s SmartSide siding won’t hold a fence load in a North Texas wind gust. That’s the kind of detail that separates a fence that’s still square after two seasons from one that pulls loose in its first spring storm.
Styles & brands we work with
Signs Your Tuff Shed Fence Installation Is Failing
Most fence failures around sheds in Dallas announce themselves early. Here’s what to look for before you’re dealing with a full section on the ground.
- Gate post lean. The post was set too shallow or the concrete collar was undersized for Dallas’s expansive clay soil, which shifts with every wet-dry cycle. A leaning gate post means the gate drags or won’t latch, and the fix almost always means resetting the post.
- Bottom rail rot at ground contact. Water pools against the bottom board where the fence meets lawn or a sprinkler zone. Untreated or improperly sealed boards rot from the bottom edge up while the rest of the fence looks fine.
- Gate sag at the hinge side. The hinge screws stripped out of the post or the gate frame was built without a diagonal brace. A sagging gate won’t correct itself, and forcing it shut makes the sag worse every week.
- Pickets pulling free from the rails. Dallas heat and wind cause repeated expansion and contraction. Undersized fasteners or nails, which is a nail instead of a screw, back out over time and let boards flap in the wind.
- Shed-to-fence gap widening. If the fence was tied to the shed and the gap between them is growing, the shed itself isn’t moving, the fence post line is drifting, usually because the posts weren’t set deep enough for the soil type.
Replacement Cost & What’s Included
In Dallas, a Tuff Shed fence installation or replacement runs $3,500 to $9,000 installed. The spread comes down to three things: linear footage, fence height and material, and whether we’re pulling out old concrete footings or setting posts in fresh holes. A 40-foot pressure-treated pine fence with one gate on flat ground prices differently than an 80-foot run of cedar with two gates on a sloped lot with rock under the soil.
Every quote from Bradford Remodeling Co Dallas is a written price before work starts, no numbers that move at the door. That price includes post removal and disposal where a fence is being replaced, concrete for every post, all lumber and hardware, and the full 365-Day Done Right Promise: if the fence fails within a year, we come back and make it right at no charge. You get the written guarantee in your hand at close-out, along with a site that’s squared away, no concrete bags, no cut ends, no stray screws.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
What you can safely do yourself: mark your property line, check your HOA rules on fence height and material, and identify where sprinkler heads and the gas line from your meter run. Those are the things that hold up a permit or cause a dig, and knowing them in advance saves time whether we do the work or not.
Where DIY goes wrong: setting posts deep enough in Dallas clay. Most weekend jobs stop at 18 inches and the first wet spring shoves the post up out of the ground. We set posts at a minimum 24 to 30 inches depth, added concrete, and sized the hole for the soil, not the post. Pulling old concrete footings is its own job, with equipment and disposal. If the job is getting bigger than a single post replacement, call us at (903) 326-8963 and we’ll give you a straight number for the whole fence, not a guess.
FAQs
A pressure-treated pine fence in Dallas lasts 12 to 18 years if the posts are set deep and the bottom rail is kept clear of soil contact and sprinkler overspray. Cedar runs 15 to 20 years. The fence usually outlasts the gate hardware, which we expect to replace at least once in that span. Call (903) 326-8963 and we’ll walk the line and tell you what you’re looking at honestly.
Post repair and single-section replacement are absolutely on the table if the failure is localized, like one leaning post or a rotted bottom rail. The judgment call is whether the rest of the fence is sound enough to tie into. A fence that’s rotting in six places gets more expensive to patch than to replace properly. Call (903) 326-8963 and we’ll tell you which one you’ve got after looking at it, no obligation.
Most standard perimeter fence installations take one to two days on site, including the old fence pull if there is one, post setting, and a day for the concrete to cure before the panels and gate go up. Weather and soil conditions can add a day. We give you the schedule in writing with the quote.
We stock pressure-treated pine, cedar, pickets, rails, posts, gate hardware, and concrete on the truck for standard fence runs. Specialty materials like ornamental aluminum or custom stains are ordered per job with lead time built into the written quote. If you’re matching an existing fence, bring us a photo of the profile and we’ll match it or tell you honestly if it’s discontinued.
Contact Bradford Remodeling Co Dallas
If you need a Tuff Shed fence installation in Dallas, or you’ve got a failing fence and you’re not sure whether it’s a $400 post or a $6,000 replacement, call us at (903) 326-8963. A live person answers, 24/7, not a voicemail. We’ll ask a few questions, get a look at the job, and hand you a written price so you know exactly what it costs before anything goes in the ground. Straight number, real scope, no surprises on delivery day.
Written by Curtis Lane, Owner, Bradford Remodeling Co Dallas at Bradford Remodeling Co Dallas, serving Dallas and nearby areas.
